Howard Lighting FSR84432ASEMV000000I 4 Lamp 32W 8' Fluorescent Retrofit Strip

Write a Review

Ask a Question

Howard Lighting FSR84432ASEMV000000I - Fixture, Fluorescent Strip Retrofit FSR8 8-foot 4.25 Wide 4 Lamp 32W T8 (2 4` Covers Instant Start Standard Ballast Factor High Effecency Multi-Volt No FIO`s w/o Power Cord Individual Carton 799385-04582 1 Case Quantity.
Up to 32% Energy Reduction with Same Light
Code Gauge Steel Construction
Designed for Trouble Free Installation
Optional Reflectors Available
UL Listed
32 Watt channel kit two 4' gear trays fully wired Efficiency ballasts

Howard Fluorescsnt Series Description:

is a simple and cost-effective solution upgrading existing 8 fixtures into newer more efficient electronic or T5 strips. 16px;">FSR8 Features:

• Designed installation.
• Uses (2) that install independently easy
• Lampholder cutouts guarantee correct lampholder spacing will not fall out during install.
• Optional available
• Code
• High gloss baked enamel finish quality holders
• NEC compliant luminaire disconnect
• Contents: 2 geartrays lampholders; 12 tek screws; geartray tethers
• Electronic Inherent Thermal Protection Class P Sound rated
• UL Listed
• System Tested Designed Approved Manufactured in Mendenhall Mississippi.

Fluorescent Applications:

Multiple configurations allow you select type number meet your criteria whether they be:

Improved Light

Energy Savings

Utility Rebates reliability

Important: Read all instructions carefully before attempting If do understand these please consult local distributor. -Thoroughly inspect the any freight damage; damage should be reported delivery carrier.

Contents: 48" one ground wire (12) screws (4) Ballast(s) pre-wired lampholders Plug

Warnings: -Risk of fire electric shock. wiring other electrical parts may damaged when drilling installation reflector hardware. Check enclosed components. Risk requires knowledge systems. qualified attempt Contact electrician. -Installation this assembly person familiar construction operation systems hazard involved. -Reflector intended used wet damp locations. only luminaires has features dimensions shown photographs and/or drawings. -To prevent abrasion expose edges sheet metal sharp objects. -Do make alter open holes an enclosure components -This use Surface Mounted Non-IC Recessed Luminaires.